HPLC Valve and Injector Accessories

MilliporeSigma™ Supelco™ RheBuild™ Kit

Kits include all of the tools and parts you need to repair your SupelPRO unit. The parts included are those most likely to be damaged, worn, or lost. Parts may vary, depending on valve model.

MilliporeSigma™ Supelco™ Reservoir for Filtration Apparatus 1

Replacement glass reservoir for Supelco™ mobile phase filtration apparatus 1

MilliporeSigma™ Supelco™ OPTI-SEAL Pump Seal

OPTI-SEAL pump seals are made from an inert, ultra-high molecular weight polyethylene material (UHMW-PE). Relative to conventional polytetrafluoroethylene (PTFE) seals, these seals show less particle shedding. This reduces the potential for clogged frits, resulting in the prevention of unscheduled system downtime.

MilliporeSigma™ Supelco™ Micro-Mixer Static Mixers (2 to 25 μL) Housing, In-Line

Thermo Scientific™ Rheodyne™ Ports for Injector Models 7010 and 9010

Use these ports for your Thermo Scientific™ Rheodyne™ 7010 and 9010 Sample Injectors for HPLC.

MilliporeSigma™ Supelco™ Rheodyne™ Model 7000 Stream Switching Valve

Number of ports: 6 and Number of positions: 2

MilliporeSigma™ Supelco™ Rheodyne™ Model 8125 Low Dispersion Injector

Manual, Dispersion injector syringe loading, Number of ports: 6, Number of positions: 2

MilliporeSigma™ Supelco™ Mobile Phase Solvent Debubbler with Bracket

Gas bubbles in the mobile phase reduce pump output and cause check valves to malfunction. The mobile phase debubbler removes bubbles from the pump inlet line. Bubbles in the incoming mobile phase rise in the debubbler, displacing an equal volume of liquid from the debubbler reservoir to the pump. When necessary, simply remove the cap and refill the reservoir -- the gas-liquid interface is visible through the housing.

MilliporeSigma™ Supelco™ Rheodyne™ Injector, Rheodyne™, 7725i

Internal position sensing switch, Manual, Number of ports: 6 and Number of positions: 2

MilliporeSigma™ Supelco™ Sample Loop for 9010, 9125, and 9725 Injectors, PEEK

MilliporeSigma™ Supelco™ TSKgel™ Hardware and Accessories

MilliporeSigma™ Supelco™ PEEK Inline Microfilter

Install between 2 pieces of capillary tubing, using Microtight tubing sleeves. PEEK housing with special PEEK fitting that encases the 0.5 μm PEEK frit. Through hole 0.006 in., swept volume 0.24 μL. Includes 2 MicroFingertight nuts, and 5 frits (1 installed).

MilliporeSigma™ Supelco™ Rheodyne™ Model 9725i PEEK Injector

Manual with MBB and switch, Number of ports: 6, Number of positions: 2

MilliporeSigma™ Supelco™ Rheodyne™ Model 9725 Injector

Manual, Number of ports: 6, Number of positions: 2

MilliporeSigma™ Supelco™ Rheodyne™ Model 7060 Selection Valve

Number of ports: 7 and Number of positions: 6